Re:4 cyl. blocks

["Myron Ware" <cmw@domain.elided>]

Jon,
  I didn't notice anything different about the exterior dimensions between 
the 152 and the 196 when I swapped engines.  The 196 was able to use the 
motor mounts that had been bolted to the 152, and the only difference I 
saw was regarding the rod that the clutch throwout fork mounts to.  There 
was a different bend in the part that attatches to the rest of the clutch 
linkage when compared to the original from the 152,
HTH,
Myron  '68 800

----Original message----
Is there any differences in the dimensions of a 152 and a 196 engine
block?  Are the supports that hold a 152 smaller than that of a 196 in the
engine compartment?

------------------------------------------------------------------------
C. Myron Ware   Senior Prog/Analyst, CNE |  NASA Langley Research Center
Email c.m.ware@domain.elided             |  Hampton, Va   23681
http://cnb-www.larc.nasa.gov/~ware/cmw-home.html  (work) or
http://www.geocities.com/Colosseum/1370  (non-work)

The main reason Santa is so jolly is because he knows where all
the bad girls live.