tranny HELP!

To: [email protected], [email protected]
Subject: tranny HELP!
From: [email protected] (Daniel Nees)
Date: Mon, 1 Feb 1999 19:19:50 -0500 (EST)
Content-Disposition: Inline
Content-Transfer-Encoding: 7Bit
Content-Type: Text/Plain; Charset=US-ASCII
Reply-To: [email protected] (Daniel Nees)
Sender: [email protected]

Allan and whomever.
   I'm trying to replace the rear output shaft main seal. I pulled the
ball bearing and beat out the old seal. The old seal was actually a
double seal, one back to back with the other. The new seal I have has
one metal sealling surface and a lip that sits back  in the back of the
seal. There is a long rubber seal portion that sticks about 1 1/2"
behind the sealling surface. The problem is that the ball bearing sits
almost right on top of this seal and there isn't room for the rubber
part behind it. 
   Now, it looks like the rubber is supposed to squash down under the
bearing. Is this correct? I don't want to install the thing unless I
know for sure. 

---------Dan Nees---------
[email protected]
2 1979 Scout II's and one 1971 Scout 810
http://members.tripod.com/~IHCaholic/scoutindex.html

Prev by Date: Re: Clutch PP
Next by Date: Antennas on 69-75 PU and TA and WM...
Prev by thread: Fitting 33s
Next by thread: Antennas on 69-75 PU and TA and WM...
Index(es):
- Date
- Thread

Home | Archive | Main Index | Thread Index