RE: Swapping 345 oil pan and pickup

["Jeff Tarquinio" <tark_terra@domain.elided>]

Thanks Epp,
That's what I wanted to know.  My spare 345 was out of my '77 tarveler (parts rig for the terra, possible fiberglass body project).  The oil pan and pickup are asll I will need since the 304 from 1100 has a rear sump.
Thanks again,
I'm being ambibitious here, but I could be done by Sunday afternoon if all goes well in acquiring the last few parts I need.  
---
Layda,
Tark
'77 Terra 345/T19/D20
   Survivor of '98 Scout Nationals
'80 Scout II 345/TF727/single speed tc
   Clean machine



On Thu, 7 Jan 1999 08:18:32    Eppinger.Michael wrote:
>Tark,
>If the stripped 345 came out of a scout II, then you will have all the parts
>you need.  You mentioned the oil pick up, I assume you have the "scout II"
>oil pump also.  If your 304 out of the 1100 pickup had a front sump oil pan,
>you will need the scout II oil pump, oil pan, and pickup tube.  If the 1100
>pickup had the rear sump pan installed, then you would need the scout II oil
>pan and pickup tube.  I think I will add a page to my web site showing a
>photo of the pans and pickup tubes side by side.  Once you see them next to
>each other, it is real clear.  Keep us posted
>
>
>Epp
>The Scout Ranch
>www.cafes.net/epp
>
>> -----Original Message-----
>> From:	Jeff Tarquinio [SMTP:tark_terra@domain.elided]
>> Sent:	Thursday, January 07, 1999 7:01 AM
>> To:	Eppinger.Michael@domain.elided
>> Cc:	ihc-digest
>> Subject:	Swapping 345 oil pan and pickup
>> 
>> Epp, IHers,
>> I remember you writing a response to someone's question about the
>> difference's betwwen pickup/t'all oil pans/pickup and Scout units.
>> Obviously, they are diffferent.  In doing my 304 swap, it came out of an
>> 1100 pickup, and I know I need the scout pan.  I have the pan and the oil
>> pickup from my "spare" (read stripped) 345.  Is this a straight forward
>> swap or are there any catches I should be concerned with?
>> Thanks in advance!
>> PS: I got the clutch pedal assy., and the shifters for my swap.  All I
>> need is the pivot pin for the tcase shift and a clutch link rod.  Maybe
>> for a clean look, a new tunnel cover for the standard setup.......wait,
>> that came out of there, where could that be.....hmmm
>> ---
>> Layda,
>> Tark
>> '77 Terra 345/T19/D20
>>    Survivor of '98 Scout Nationals
>> '80 Scout II 345/TF727/single speed tc
>>    Clean machine
>> 
>> 
>> 
>> 
>> Angelfire for your free web-based e-mail. http://www.angelfire.com
>


Angelfire for your free web-based e-mail. http://www.angelfire.com